GINGIVA
GINGIVA
- Tear resistance gingival masks
- Flexible and easy to trim
- Produced under ISO standards 13485:2016
- Find here validated DLP, LCD 3D printers list
*Disclaimer: All European customers please add your valid VAT number during check out! Check here how to add VAT
Please find post processing and instructions for use here. Technical questions reach us via support@3bfab.com.
Product Description
Product Features
- Tear resistance gingival masks
- Flexible and easy to trim
- Produced under ISO standarts 13485:2016
- Find here validated DLP, LCD 3D printers list
Material Properties
Material Properties | Value | Standard |
---|---|---|
Tensile strength | 2.2 Mpa | ASTM D638 |
Flexural strength | 1.1 Mpa | ASTM D790-02 |
Elongation at Break | 24.5% | ASTM D638 |
Shore Hardness | 81 A | ASTM D2240 |
Density | 1.104 g/cm3 at 23 C | ASTM D1475 |
Viscosity | 1145 mPa.s at 23 C | DIN 53211-4 |
Color | Pink |
Post Process
1- Washing
After the printing is completed, wash the part as attached to the building plate with ethyl alcohol (>%90) or isopropyl alcohol (>%90) for 5 minutes. Make sure that alcohol covers the part entirely when washing. Do not over-wash, it may cause deterioration in dimensions of the part.
2- Drying
Use air-compressor to dry the washed part. Make sure that the part is dry and uncured resin is cleaned up completely. If there is still uncured resin left on the part, wash it with fresh alcohol and dry again.
3- Part Removal
Remove the printed part from the build plate using a scraping tool. Be very careful not to damage the model.
4- Post Curing
Post curing application does not significantly affect the Gingiva resin's mechanical properties. However, post-curing helps to remove the stickiness on the printed pieces; thus, the following process is suggested for easy use: 10 minutes with MEDIFIVE curing chamber at 3rd-degree light intensity Otoflash curing recommendations 1000 flashes without gas.
Storage Conditions
Store the PowerResins Temp bottle in dark and moisture free place at room temperature (20-24 °C).
Do not forget shaking the resin well before use.
If your printer has heater, you can set the temperature at 32 °C. Otherwise, you can heat your resin in a microwave for 18 seconds or by submerging in hot water for 15-20 minutes.
-
FLEXIBLE RESIN
It is produced to imitate the gingiva with its flexible structure.
-
NATURAL COLOR
Allows you to work more easily with skin color and contains no pigment solution
-
TEAR-RESISTANCE
Gingiva can be easily trimmed to reach optimal fitting for the implant models.
-
SAFE & NOT SMELLY
Safe to handle. Does not contain any hazardous solvent or dangerous monomer.